Open a Command PromptĪnd navigate to that folder. When the NSPanel Pro is connected to your computer via USB you should have a new device in Device Manager.ĭownload the Android platform-tools and unzip the contents to a folder. Remove the tape from the touch panel connector and disconnect the connector to lift up the PCB.Ĭonnect the data USB cable from your computer to the OTG port. Unscrew the two screws on the back then carefully pry away the back plate starting at this point. Just install ADB and connect immediately with adb connect and jump to Using ADB Disassembly For those you can skip the disassembly and USB cable. The simplest way to do that is with Android Debug Bridge.Įdit Upon further inspection it seems ADB over TCP is enabled by default on some devices or can be enabled when developer mode is activated by tapping the Device ID 8 times to enable developer mode in eWeLink app Device Settings of NSPanel Pro. You can still grab an NSPanel Pro for a presale discount on Itead store.Īfter the initial shock and disappointment with the release firmware and a smaller scale repeat of that with the September upgrade I decided to go deeper.

Shopping links in this article are affiliate links and I earn a small commission when you buy through them Some aspects of it might be changed in official release.

Full disclosure: This is a pre production unit sent to me free of charge by Sonoff.

Disassembly for apple instal